The balanced rotating assembly (typically includes crankshaft, pistons, rings, connecting rods, rod bearings, and balancer) featured in this engine:

• 3.000" crank 
• 5.090" rods with ARP rod bolts
• 8½ to 1 compression pistons

More special features of this engine include:

• Seasoned block that has been vatted, magnafluxed for cracks, thermal cleaned and steelabrated, bored, honed and plateau honed to fit new flat top oversized pistons
• Deck head gasket surface on block to ensure a good long lasting seal
• New Hydraulic flat tappet cam to put the focus on low end and midrange power
• High quality Edelbrock 356A Aluminum performance heads
• New 2.02"Int/1.600"Exh stainless valves with undercut stems to improve flow
• Heads have 3-angle valve job
• New Hardened exhaust seats for use with leaded or unleaded fuel
• New High performance springs set up to match cam
• New Valve seals
• New Valve guides
• New Screw-in rocker studs
• New 1.6 roller tip rocker arms with balls and nuts
• New Oversize pistons and rings
• New Heavy duty double row timing set
• New High volume oil pump
• New Brass expansion plugs
• New Main and rod bearings to fit 3.000" stroke crankshaft
• New Edelbrock Air Gap aluminum intake manifold
• All parts are painted separately before assembly for that show quality look

This Is A Real Turnkey Engine

This engine has been started on gas and run. The camshaft has been broken in and the valves adjusted. Carburetor and timing has been initially set, but should be checked after installing in vehicle.

Also included and installed on engine:

• 4bbl carb
• Fuel pump
• Chrome air cleaner
• Fuel filter
• Electronic distributor and coil
• Spark plugs and spark plug wires
• Water pump
• Crankshaft and water pump pulleys
• Alternator with bracket and alternator belt
• Starter
• Water outlet and thermostat
• Starter alignment plate for back of block
• A/T Flexplate with bolts
• This engine has been started on gas and run. Carburetor and timing has been initially set, but should be checked after installing in vehicle.

Not included on this engine:

Exhaust manifolds, hoses, fan, accessory belts (except alternator belt), radiator, linkage or miscellaneous.

This engine comes completely assembled with rear sump oil pan, dipstick and dipstick tube, timing cover, harmonic balancer, valve covers, and Edelbrock Air Gap aluminum intake manifold.

This engine is custom built from start to finish in our state of the art facility by professionals that take pride in their work to guarantee that you get a top quality engine the first time!.